Project Badgermascus – Part 9 – Almost Done


The knife is done about 95% now. I have peened and ground flush all the pins on scales without some major failure, although there did appear one tiny crack near one of the pins ‘sigh’. I have sealed the crack with super glue and sanded it over, there is nothing else that can be done about it.

I did not do a very good job at the pins, I must say. I think the mistake that I make is leaving myself way too much material to move, which leads to a lot of problems later on. I must remember that for 3 mm pin it is quite enough to peen less than 1 mm material into a recess just 0,5 mm deep. It is not as if the pins need to hold extra-strongly.

But, it is done and it is what it is. I applied a little bit of patina to the pins. Not to make them black, just to make them ever so slightly aged. Funnily enough, the patina has highlighted some of the imperfections – and that made the whole assembly to look actually better. Only you must forgive me for now for not revealing the whole knife yet. There is still a lot of work to do before I consider it publication-worthy, do not expect that very soon.

© Charly, all rights reserved. Click for full size.

I am thinking now how to best seal the surfaces and the patina. Either beeswax, or drying oil. Or both. Any suggestions? I have zero experience with patina on metal jewelry, which essentialy is what this is.

Comments

  1. voyager says

    I hope the finishing details go smoothly. I’m quite looking forward to seeing the final reveal.

Leave a Reply